clickstick | Smart accurate dosage deodorant dispenser

Instructions:

Device Activation:

To activate the device, remove the cap- the light turns on.
Before using the device, remove the seal.
When you press on the switch, the electric motor moves for a predetermined amount.
For first time usage press on the switch few times until the deodorant comes out from the top.
You need to wait 2 seconds between switch activation. This feature is implemented in order to prevent accidental usage.
Every time you press the switch, you get exactly the same amount of deodorant out.
Note that device goes into sleep mode after 45 seconds of no activity. To get the device out of sleep mode, place the cap back and remove it again.
Make sure to place the cap back after each use to prevent the deodorant from drying and ensure that the device is ready to use the next time you need it.

To change the amount:

Press on the switch and hold for 3 seconds until the light flashes (Clickstick enters programming mode).
Click on the switch 1 to 7 times to set the desired amount. Default setting is level 3.
Wait untill the light flashes to confirm selection (Clickstick exits programming mode).
When the light turns on again, the device is ready to use.

To replace the refill cartridge:

To decouple the refill cartridge from the holder: Hold ClickStick and press with your fingers on the bottom part of the cartridge while sliding it upward using your other hand.
To place a new cartridge: Slide the new cartridge into ClickStick until you hear a clicking sound. You might have to move the cartridge a bit while pressing it to ensure proper coupling. When the refill cartridge is properly coupled, you cannot remove it by sliding it up.

Troubleshooting:

Device does not turn on when the cap is removed (no light):

When removing the cap, some deodorant residues are on the top of the device:

Initial setup

Refill cartridge replacement